Troubleshooting Nissan Bolts that are Difficult to Remove for Nissan Titan
Updated 10/30/2025 | Published 02/06/2025
Question:
My bolts that were installed at the Nissan factory are impossible to take out. I have read were other installs they had to deal with broken bolt heads on their Nissan Titan. What do I need to do to mine ?
asked by: Steve
Expert Reply:
Hey Steve, it's probably red Loc-Tite that is holding the bolts in so tightly. The solution for that is heat. If you have a torch heat the bolt up quite a bit and try again. That should melt the Loc-Tite and allow the bolt to unthread. I dealt with exact same thing with my Tahoe when I replaced the rear bumper beam with a hitch. It was so brutal haha. I wish I had known at time to put a torch on it.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 800 lbs TW
- 8000 lbs GTW
- 12000 lbs WD GTW
- 2 Inch Hitch
- 1200 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Disc Brake Pads for a Dexter 89-3 Caliper
- Q&A: What is the Size Difference Between a 205/75-14 and a 215/75-14 Trailer Tire
- Q&A: Inner and Outer Diameter of the Chrome Edge Trim SAT012ET
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Is There Trimming Required to Install etrailer Base Plate Kit # e96GV on 2025 Ford Maverick
- Q&A: Where is Brake Controller Install Port on 2016 Ram 1500
- Q&A: Lock Options for Use with Curt 4-Bike Tilting Hitch Rack C18030
- Q&A: Folding Hinge for 2 x 2 Inch Trailer Tongue
- Article: How to Choose the Right Trailer Hitch Class
- Article: Can You Flat Tow a Jeep Compass?
- Article: Is It Illegal to Leave My Hitch on My Truck?
Jameson C.
10/30/2025
Hey Steve, did heating the bolts on your Titan help loosen them up? Your results could really help others running into the same issue with factory-installed bolts.