Will the Curt 2 inch Bumper Hitch Fit On a 2000 GMC Jimmy
Updated 12/29/2009 | Published 12/27/2009
Question:
will Part E-3s fit on a GMC Jimmy 2000?
asked by: larry c
Expert Reply:
If you 2000 GMC Jimmy has a rear step bumper and the mounting hole spacing is 8-3/4 inches on center then the Curt 2 inch Bumper Hitch, item # E-3S, will work on your vehicle. The towing capacity of the hitch will be the lowest rated item in the system which are the vehicle, bumper or hitch itself, whichever is lowest. You can find the towing capacity either in your owners manual and/or on the bumper itself.
The Curt 2 inch Bumper Hitch comes with all of the mounting hardware and instructions needed for installation. When installing the hitch you will have to remove the covers on your step bumper to expose the mounting holes. Once this is done the hitch is a simple bolt on installation.
Product Page this Question was Asked From
Curt 2" Trailer Hitch - Bumper Mount - 8-3/4" Bolt Pattern - 5,000 lbs GTW
- Bumper Hitch
- 500 lbs TW
- 5000 lbs GTW
- 2 Inch Hitch
- Bolt-On
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Front Hitch Recommendation for Bike Rack for 2004 Fleetwood Tioga
- Q&A: Can Dylux Tankless RV Water Heater Be Used In Winter? Does It Have Freeze Protection?
- Q&A: Front Mount Hitch for 2000 Ford E-450
- Q&A: Does Front Plastic Valance Get Removed to Install Curt Front Hitch # 33055
- Q&A: How to Determine the Correct Replacement Wiper Seal for a 2017 Keystone Bullet 243BHS
- Article: Trailer Wiring Diagrams
- Q&A: RV AC Unit Recommendation for 14 inch Roof Opening that Doesn't Require Wall Thermostat
- Q&A: Kelvin Rating Of The Command Electronics 12v RV LED Puck Light # CE68ZR
- Article: Types of Trailer Hitches: How and Why to Use Each
- Article: My Trailer Hitch Doesn't Fit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Determining Trailer Tongue Weight