Is CE Smith Steel Step for Trailer Fender # CE19012 Made of Stainless Steel
Updated 06/09/2014 | Published 06/06/2014
Products Featured in This Question
Question:
Hello, I work for FLIR Systems and was looking at the CE Smith Steel Step for Trailer Fender - 7inch x 3inch - Right Front/Left Rear - Qty 1. For our project we require corrosion resistant materials and I saw that this product is made of steel but is it stainless steel? Thank you
asked by: Nicholas G
Expert Reply:
The CE Smith Steel Step for Trailer Fender # CE19012 that you referenced is not made of stainless steel. It is made of 11-gauge steel that is intended to be primed and painted before being bolted or after being welded in place. The matching part for the opposite side is # CE19011.
Product Page this Question was Asked From
CE Smith Steel Step for Trailer Fender - 7" x 3" - Right Front/Left Rear - Qty 1
- Boat Trailer Parts
- Steps
- 3 Inch Wide
- 7 Inch Long
- CE Smith
more information >
Continue Researching
- Q&A: Replacement Parts to Rebuild Trailer Suspension on 1976 EZTrail
- Q&A: What is the Radius of CE Smith Single Axle Trailer Fender CE17701G
- Q&A: How Does the Submersible, Under 80" LED Trailer Light Kit part # TLL9RK Wire to Trailer
- Q&A: Do You Have a Complete Wobble Roller Bunk Assembly?
- Q&A: What Diameter are the Chain Anchors on the Demco A-Frame Trailer Coupler DM13205-95?
- Q&A: What is the Correct Torque Rating for a ST205/75R15 Trailer Tire and Wheel
- Q&A: Replacement 11-Pin Wire Harness Repair Kit for a Fisher 7.5 Snow Plow
- Article: Boat Trailer Guides: Which are the Best?
- Article: Rust Prevention
- Article: Where to Position the Trailer Axle?
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Article: How to Launch a Boat from a Trailer (And Load it Back Up)
- Article: How to Install E-Track in 3 Easy Steps