Troubleshooting Turn Signals Staying On Constantly With No Turn Function
Updated 11/17/2025 | Published 12/11/2024 >
Question:
I have a marker/turn light. It has a brown wire, red wire and a blade welded to the metal base part of the light. I assumed that the red is the hot, brown is neutral and the blade was the ground. I am getting a constant marker with no turn function. Any suggestions? Thank you all for your help.
asked by: Aaron
Expert Reply:
Hello Aaron, thanks for reaching out. The functions you listed for your light are correct. There are a lot of lights that will ground thru the metal base or mounting hardware instead of having a ground wire. That said, as long as you are sure the red wire is connected to the turn signal circuit, the issue you are describing sounds like a bad ground. Check the metal blade and mounting hardware and make sure it is grounded to good clean metal free of any rust or paint. Make sure you are connected to the right circuit and check that ground and let me know how it goes.
Product Page this Question was Asked From
LED Trailer Clearance or Side Marker Light with Reflex Reflector - 2 Diodes - Red Lens
- Trailer Lights
- Clearance Lights
- Marker
- Oval
- Surface Mount
- Non-Submersible Lights
- LED Light
- 4L x 1-1/2W Inch
- Red
- Command Electronics
more information >
Continue Researching
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Q&A: Replacement Clearance Lights For Glo Brite 122r/122y
- Q&A: How Much Does The TA35ZR Taskmaster Modular Wheel Weigh?
- Q&A: Gooseneck Pinbox to Replace Curt Helux on 2026 Alliance Paradigm
- Q&A: Replacement Clearance Lights Needed for GLO-BRITE 122R and 122Y Lights
- Q&A: Bearing Kit for Lippert 4,400 lb Trailer Axle
- Q&A: Replacement Hub and Drum Assembly for Lippert 4,400 lb Axle
- Article: Stability Control for Heavy Duty Vehicles
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Curt Echo Full Review
- Article: Trailer Lighting Requirements
- Article: The Ultimate RV Camping Checklist for Your First Year RVing


Jesse M.
11/17/2025
Hey Aaron, did cleaning the ground connection on your marker light fix the turn signal issue? Your update could make it easier for others troubleshooting a similar wiring setup.