What is the Minimum Roof Thickness to Install the Furrion Chill Cube RV Air Conditioner
Updated 08/31/2026 | Published 11/18/2024
Products Featured in This Question
Question:
What is the minimum roof thickness required the Furrion Chill Cube RV heat/pump. I have 1inch fiberglass
asked by: Anthony C
Expert Reply:
Hey Anthony,
The Furrion Chill Cube RV Air Conditioner # LC22BX requires a roof thickness of 3.5" to 6" according to the Furrion installation instructions.
Since your roof is less thick than this you'll need to install some bracing into your fiberglass. I'm attaching an installation video where Shane added some bracing to a Ford Transit in order to install the MaxxFan Deluxe # MA00-06200K that you can use as an example.
Anthony
8/31/2026
Where is that video at
Jerry B.
8/31/2026
Product Page this Question was Asked From
Furrion Chill Cube RV Air Conditioner - 18,000 Btu - Non-Ducted - Black - R32 - AC Unit Only
- RV Air Conditioners
- AC Unit Only
- Cool Only
- 18000 Btu
- Standard Height
- Single Zone
- Rooftop
- Non-Ducted
- Black
- Furrion
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Search Results: trailer door latch
- Search Results: timken bearing for dexter 3500 lb axles
- Search Results: rv door locks
- Search Results: rv toilet flange
- Q&A: Will Furrion Chill Cube Work On Sloped Roof
- Video: Installation: MaxxFan Deluxe Roof Vent w/ 12V Fan and Thermostat on a 2017 Ford Transit T150
- Search Results: furrion rv air conditioners
- Search Results: rv water pump
- Shop: Replacement RV Toilet Floor Flange - 3" MPT
- Search Results: rv air conditioners
- Shop: Furrion Chill Cube Variable Speed RV Air Conditioner - 18K Btu - Non-Ducted - R32 - AC Unit Only
- Shop: Timken 473336 Grease and Oil Seal - Double Lip - I.D. 1.719" / O.D. 2.565" for 3.5K Axles
- Shop: RV Exterior Lighting
- Video: A Closer Look at the RV Rectangular Porch and Utility Light with Switch
- Shop: Replacement Universal Ignition DC Furnace Control Board for Atwood Hydro Flame Furnaces
- Shop: Replacement 4-in-1 Elbow Adapter for SewerSolution Macerator System
- Shop: Timken Replacement Bearing and Race Set #4 - L44649 and L44610
- Shop: RV Rectangular Porch and Utility Light with Switch - Clear
- Video: A Look at the Power Mountain Tallboy 6 Ton Off-Road Bottle Jack with a Military Cargo Trailer
- Shop: Brake Controller
- Q&A: Is Furrion Chill Cube on Brinkley RV Compatible With Heat Strip
- Q&A: Replacement Air Distribution Box for a Furrion Chill Cube
- Q&A: Will Redarc Tow-Pro Link Work On 2021 Silverado 1500 With Factory Brake Controller
- Q&A: Replacement Circuit Board For Dometic Atwood Water Heater With Circuit Board 91346
- Shop: RV Interior Lighting
- Q&A: Recommended Replacement For MORryde STP-017 StepAbove RV Steps
- Video: All You Need to Know About the Dexter Trailer Springs Over-Under Conversion Kit
- Shop: UTV Tops
- Article: Tips on How To Tow a Trailer
- Video: Review of Specialty Recreation RV Skylight - 14 X 22 Rectangular Kit - SR66MR
Kate F.
12/15/2025
Hey Anthony, how did things go adding the bracing for your fiberglass roof to fit the Furrion Chill Cube? Sharing what worked could help others with thinner roofs facing the same challenge.