Crossmember for Landing Gear Legs
Updated 10/27/2024 | Published 10/18/2024
Products Featured in This Question
Question:
Looking for the cross bar to make both sides of landing legs lower at the same time
asked by: John K
Expert Reply:
Hi John; I don't know what kind of landing gear you have but the # BDCS730300 is designed for the Bulldog landing gear # BD500153 or BD1823050383 and is 1" wide x 72-3/4" long. If you have this landing gear, or other landing gear compatible with a 1" wide round tube, this will work with your setup. We also have the Replacement Cross Members for Stromberg Carlson Landing Gear # SC46MR. This extends from 40-1/2" to 68-1/2" wide and is made of 1" and 3/4" square steel tubing.
Product Page this Question was Asked From
Cross Shaft Extension Tube for Bulldog Tandem Landing Gear - 72-3/4" Long - Fixed
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Crossmember
- Bulldog
more information >
Continue Researching
- Q&A: Difference Between Bearing Buddy 2047 and 2047SS
- Q&A: Does Dexter Vault System Work the Same As Bearing Buddy
- Q&A: Powering Interior Trailer Lights With Generator
- Q&A: Replacing Lippert 3,500 Pound Axle with 76 Inch Spring Seat Length
- Q&A: Recommended 7-Way To Hopkins Molded Trailer Wire with Different Colors
- Q&A: Recommended Brake Assembly 12x2 with 4 Bolt Mounting Pattern
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Article: Double-Eye Trailer Suspension System Review
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation on a Ford Super Duty Truck (2005-2007)
- Article: Trailer Maintenance Schedule
- Article: Converting Your RV Water Heater to Tankless
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
John
10/27/2024
Thank you that will work great service