Looking For Replacement L-Pin For Equal-i-zer Weight Distribution System
Updated 12/22/2025 | Published 10/13/2024
Question:
I have a L pin for equalizer bars that is 5/8 thick do you carry that part I need two thank you the bars are 3 years old
asked by: Ross
0
Expert Reply:
Hey Ross, thanks for reaching out. We have one Replacement L-Pin for Equal-i-zer 4,000-lb Weight Distribution Systems part # 90-03-9460 but ours measures 1/2" thick. The length of the long side is 2-1/2" long, the short side measures 1-1/2" long and the thickness of the pin is 1/2". If you need a new L-bracket to go with it use part # EQ57FR.
expert reply by:
Jesse M
0
Product Page this Question was Asked From
Equal-i-zer Weight Distribution System w/ 4-Point Sway Control - 4,000 lbs GTW, 400 lbs TW
- Weight Distribution Hitch
- WD With Sway Control
- Trunnion Bar
- Fits 3 Inch Frame
- Fits 4 Inch Frame
- Fits 5 Inch Frame
- Fits 6 Inch Frame
- Includes Shank
- Top-Mount
- Fits 2 Inch Hitch
- Allows Backing Up
- 200 lbs
- 300 lbs
- Equal-i-zer
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Hitch, Weight Distribution and Brake Controller Recommendations for a 2017 Toyota Sienna XLE
- Q&A: Weight Distribution Hitch Recommendation for 8,500 lb Travel Trailer
- Q&A: How Does Andersen Weight Distribution Reduce Sway Without Friction Bars?
- Article: Best Bike Racks for Electric Bikes
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Q&A: Upgrading a 12K Equal-I-zer Weight Distribution System to a 14K
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Replacement Control Panel and Circuit Board for LCI Electronic Leveling System
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Lighting Requirements
- Q&A: Recommendations and Measurement for Solera RV Slide-Out Awning
- Q&A: Recommended Solera Slide Topper For A 150" Flange To Flange Measurement
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Jacks
Jesse M.
12/22/2025
Hey Ross, did the 1/2-inch L-pin and bracket end up working with your Equal-i-zer setup? Knowing how it fit could help others trying to match older bars.