Is Replacement Latch Assembly Available for Valley 5131 Coupler
Updated 12/22/2025 | Published 09/29/2024
Question:
I have a tilt trailer with a Valley 5131, CLI-1 7/8, 2000 LB, 200LB tongue V-5. All the latch parts are gone. What latch assembly do you have that will work?
asked by: Richard
Expert Reply:
Hey Richard, thanks for reaching out!
We've referenced to others trying to use the Curt Coupler Repair Kit # C25194, but we don't have a way to confirm this since Valley went out of business quite a while ago.
Your best bet is to swap out your coupler entirely. I don't have any specs of what your coupler looks like but if you let me know what it looks like I'd be more than happy to help you choose a replacement from our linked selection.
Product Page this Question was Asked From
Curt Coupler Repair Kit for 2" Posi-Lock Coupler Latches - Curt Straight Tongue Couplers
- Accessories and Parts
- Straight Tongue Trailer Coupler
- Coupler Repair
- CURT
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Is There a Weld Pattern for the Sleeve-Lock A-Frame Trailer Coupler # CA-5296-B?
- Article: Trailer Wiring Diagrams
- Q&A: Availability of Replacement Grease Seal 450133
- Q&A: What Brake Controller For 2020 Chevy Colorado & Is There Plug-In Harness
- Q&A: How to Check for a Bent Trailer Axle Spindle
- Q&A: What is the Difference Between ST205/75-14 and ST215/75-14 Size Tires
- Q&A: Dimension of Flexco Manual Step # SMFP-1100 When Folded In
- Article: 7 Steps to Clean Your RV Awning, Prevent Mold, and Save Money
- Q&A: Are Two Wires Required to Install the Clear Utility Light # 507-12 on a Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: What Do I Need To Tow A Trailer?
- Article: How (and Where) to Connect an RV Propane Grill
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Tell the Weight Rating of a Trailer Axle
Jameson C.
12/22/2025
Hey Richard, did you get a chance to find a coupler replacement for your tilt trailer? Once you know what your old coupler looks like, I can help narrow down the best match. Your update could make it easier for others working with older Valley couplers.