Mounting Hole Spacing For The Dometic RV Furnace Access Door # DMC57RR
Updated 01/05/2026 | Published 09/01/2024
Products Featured in This Question
Question:
What are the mounting hole spots for the DMC57RR?
asked by: John
Expert Reply:
Hey John,
I drew up a little diagram showing the spacing for the mounting holes in the Dometic RV Furnace Access Door # DMC57RR flange and access door. For mounting the flange to the RV walls you'll go with the holes spaced further out at 17-1/8" x 6-5/8". I would definitely use some butyl tape # AL28FJ on the back side of the flange to help prevent any water from leaking in through the screw holes.
Once you have the furnace in place and the access door mounted you can also run a bead of non-sag sealant # 344270341437-1 around the outer edge of the door to really ensure a waterproof seal.
(click to enlarge)
Product Page this Question was Asked From
Dometic RV Furnace Access Door - 19-1/16" Wide x 9-1/2" Tall - Black
- Accessories and Parts
- RV Furnace
- Doors
- Black
- Dometic
more information >
Continue Researching
- Shop: Dometic RV Furnace Access Door - 19-1/16" Wide x 9-1/2" Tall - Black
- Search Results: awning motor
- Search Results: furnace vent
- Search Results: insert trim rv trim
- Search Results: furnace exhaust
- Q&A: Can The PowerMax Wireless 50A RV Power Center and Distribution Panel PM77VR Be Mounted On Its Side?
- Shop: Specialty Recreation Heavy-Duty Skylight Kit - 14" x 22" - Smoke
- Search Results: backsplash
- Q&A: Is It Worth Upgrading Old WFCO 8900 Series Power Center To New PowerMax PM77VR In My Travel Trailer?
- Shop: RV Designer Standard Vinyl Trim Insert - 25' x 1" - White
- Video: Review of PowerMax RV Power Converter - Wireless 50A RV Power Center Distribution Panel - PM77VR
- Search Results: transfer switch
- Search Results: thetford seal
- Video: Review of Dometic RV Furnace Access Door - DMC57RR
- Q&A: Correct Replacement Door for Atwood GC6AA-9E Water Heater
- Video: Let’s Check Out the Replacement Door for Atwood RV Water Heaters
- Shop: Replacement Exterior Door Kit for Fogatti RV Furnace - InstaHeat Ultra Series 35,000 Btu - White
- Shop: PowerMax Wireless 50A RV Power Center and Distribution Panel - 60A DC Converter
- Q&A: What Should I Use Around My RV Tail Light When Installing a Replacement?
- Shop: Dometic RV Furnace Access Door - 14-3/8" Long x 9-3/8" Tall - Black
- Shop: Replacement Black Door for 6-Gallon Atwood Water Heater
- Video: Genesis Revive RV Wall Coverings – At a Glance
- Video: Review of P and F Products Trailer Trim - Top/Bottom Edge - PF66FR
- Shop: RV Roof Membrane
- Video: Review of Dometic RV Furnace Access Door - DMC24RR
- Q&A: Inside Dimensions for Dometic RV Furnace Access Door
- Q&A: Replacement Fridge Vent for 2018 Coachmen Orion 21RS
- Video: Breaking Down the LaSalle Bristol XTRM Universal Non-Sag Sealant for RVs
- Q&A: Can PowerMax PM77VR 60A Power Center For RV Be Used Manually Instead Of Wireless Controls?
Jerred H.
1/5/2026
Hey John, how did the mounting go with the Dometic furnace access door and the flange spacing you used? It’d be great to hear if the butyl tape and sealant gave you a good waterproof seal. Your update could make it easier for the next person working on the same setup.