Will Titan Model 6 Actuator Work with a Reverse Lockout Solenoid After Orifice Fitting is Removed
Published 05/21/2014
Products Featured in This Question
Question:
I want to install a T4748800 lockout solenoid valve on my titan model 6 actuator. The fitting I have to remove to install it has a very small orifice. Will the system work properly without this restricting orifice?
asked by: Don W
0
Expert Reply:
Yes, I spoke with my contact at Titan and after you remove the small orifice fitting part # T1209800 from your Titan model 6 actuator you would be able to install the Lockout Solenoid part # T4748800 and your brakes will activate correctly.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Solenoid Valve for Dexter Brake Actuators with Reverse Lockouts
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Hydraulic Drum Brakes
- Solenoid
- Valve
- Dexter
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: My Surge Brakes Are Activating When I Back Up My Trailer - What Can I Do?
- Q&A: Replacement for Atwood 61101 Brake Actuator
- Q&A: Replacement for Atwood 82543 Surge Brake Actuator
- Q&A: Replacement for a Tie Down Model 66 Drum Brake Actuator
- Q&A: Surge Brake Actuator to Replace Atwood 82543
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Hydraulic Trailer Brakes: How They Work & What to Buy
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Most Popular Wheel Bearings