Distance From Pin Hole to Curve of Curt Ball Mount # C45459
Updated 01/27/2026 | Published 08/18/2024
Question:
What is the measurement from center of pin to the start of the downward curve? I what to use a rock -mud flap that is shank mounted. It requires a 1 3/4 in space between receiver and the ,
asked by: Chris
0
Expert Reply:
Hey Chris that dimension is going to be right at 4 inches on the Curt Ball Mount part # C45459. This is a pretty typical dimension for ball mounts that fit this hitch size and have a 6 inch drop.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Ball Mount for 2-1/2" Hitches - 4-1/2" Rise, 6" Drop - 20K
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- Steel Shank
- Drop - 6 Inch
- Rise - 4 Inch
- Fits 2-1/2 Inch Hitch
- 20000 lbs GTW
- CURT
more information >
Continue Researching
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Will The Curt Trailer Hitch Receiver C82RJ Fit The 2027 Kia Telluride
- Q&A: Do Curt Single Hook Coiled Safety Cables Meet Legal Requirements for Towing
- Q&A: Correct Replacements for Dexter 023-359-00 Left Hand and 023-360-00 Right Hand Braking Assemblies
- Q&A: Replacement Connector for a Pollak PA66-MD40
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Replacement for Atwood AMPlock Trailer Coupler Lock Part AT89004
- Q&A: How to Make an Adapter to Go from Semi Truck 7-Way Round to RV Style 7-Way Blade on Trailer
- Q&A: Replacement Brake Assemblies for Dexter Trailer Hub 9-44
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: How to Install E-Track in 3 Easy Steps
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Which Sway Control Hitch is Right For Your Trailer?
Jameson C.
1/27/2026
Hey Chris, did the 4-inch measurement on the Curt ball mount give you enough space for your rock-mud flap setup? Your update could make it easier for others trying to fit similar accessories.