What Brand Of Jack Is On My Gooseneck Trailer And Availability Of Replacement Gears
Updated 01/19/2026 | Published 08/04/2024
Question:
I have a square down jack for a gooseneck horse trailer that I need to replace the gears on. The trailer is a 6 horse Cato Classic. mfg in 2000. It has a side pull release pin, that looks like the one from buyers productsinch The 2 speed box looks like the bulldog. It does not have a spring return It is welded on There is a metal ID plate attached with the following information embossed. LG 4777-30000 3932 Any idea what brand this might be?
asked by: Kathy D
(click to enlarge)
(click to enlarge)
Expert Reply:
Hello Kathy, thanks for reaching out. That does look similar to a bulldog jack, but I did not find any reference for the part number you provided, so I cannot confirm what brand that is. Without knowing the brand it is not possible to recommend a replacement gear kit. Even if we did know the brand, it is likely that a gear kit is not available since the jack is so old. In this case your best bet will be to replace the jack entirely. The Square Jack # TJD-12000SP-F2 is a very popular square jack. The outer tube is 4" wide, it has 25-7/8" of total travel and a 10K lift capacity. Please take a closer look at your jack and confirm these dimensions.
Product Page this Question was Asked From
etrailer Square Direct Weld Jack - Drop Leg w/ Spring Return - Sidewind - 25-7/8" Lift - 10K
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- 5th Wheel Trailer
- Gooseneck Trailer
- Side-Mount Jacks
- Sidewind Jack
- 9001 - 10000 lbs
- Manual Jack
- 26 Inch Lift
- Weld-On
- With Rectangle Foot
- etrailer
more information >
Continue Researching
- Shop: Replacement Lifting Nut for Curt Heavy Duty Direct Weld Square Jack
- Shop: Replacement Rod and Nut for etrailer and Ram Square, Direct Weld Jacks - 12K
- Shop: Replacement Square, Direct Weld Jack Inner Tube with Spring-Return Drop Leg
- Q&A: Looking For Replacement Pins For etrailer Adjustable Ball Mount e66PR
- Q&A: Replacement Parts Available for the RAM Trailer Jack Part # TJD-7000S
- Q&A: How to Replace Interior Ram Jack Rod and Nut # TJD-12000-RODNUT on 12000 Series Jacks
- Q&A: How Far Does Trailer Tongue Slide Into SwingKing Bolt-On Swing Tongue Kit
- Q&A: Can the Square 2-Speed Jack w/ Crank Be Used In Tandem
- Q&A: Replacement Parts for the Square Direct Weld Jacks
- Q&A: Availability Of Gooseneck Coupler Inner Tube With 3-3/4" Outer Diameter
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Trailer Maintenance Schedule
- Article: Double-Eye Trailer Suspension System Review
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Can You Flat Tow a 2025 Cadillac Escalade?
Jesse M.
1/19/2026
Hey Kathy, did the square jack you looked at match the dimensions of your old one on the Cato Classic trailer? Knowing how the fit turned out could help others replacing older welded jacks too.