Will Dexter Hub 008-259-05 From Torsion Axle Fit Standard Dexter 2k Axle
Updated 02/03/2026 | Published 07/23/2024
Products Featured in This Question
Question:
I currently have Dexter 9 Torflex axles with hub 008-259-05 and want to swap to a straight axle with leaf springs. Will my current hubs fit on a standard 2000 lb capacity Dexter leaf sprung axle?
asked by: Hilton H
Expert Reply:
Hi Hilton; the spindle on your typical 2k axle uses # L44649 or # L44643 bearings. The 008-259-05 hub you have now is able to use both. You will need to make sure the bearings match the spindle of your replacement axle before you install the hubs on the spindle. These can be swapped out in the hub using the same # L44610 races so if you have # L44649 bearings and need # L44643 all you need to do is buy a new set of bearings to make it work.
Product Page this Question was Asked From
Timken Replacement Trailer Wheel Bearing - L44649
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.06 Inch I.D.
- Bearing L44649
- Race L44610
- 3500 lbs Axle
- Timken
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Most Popular Wheel Bearings
- Q&A: What Timken Bearings, Races, Washer, and Cotter Pin do I Need for My 2,200 BTR Spindle/Axle?
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Are Pacbrake Alpha HD Air Bags Compatible With Turnoverball On 2024 Ford F-250
- Q&A: How to Determine Replacement Trailer Wheel Bearing Sizes
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: Replacement for Dexter 8-283 Hub/Drum
- Q&A: What Is The Smallest Available Spindle Nut For 2.5k Axle?
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Which Style Tire Pressure Monitoring System Is Best?
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Install E-Track in 3 Easy Steps
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Wiring Diagrams
Robin H.
2/3/2026
Hey Hilton, how did the hub swap go when you matched the bearings to your new 2,000‑lb axle? Knowing which bearing size worked best could help others doing the same conversion.