Toolbox Compatible Tonneau Cover For A 2024 Ford F-350 With An 8' Bed
Updated 02/03/2026 | Published 07/15/2024
Question:
I just purchased a 2024 ford f 350 long box and was seeing if I put a toolbox on. Do you have a hard tonneau cover tri fold. That would work with the toolbox. Thanks. Troy
asked by: Troy. B
0
Expert Reply:
Hey Troy,
The only toolbox compatible tonneau cover we currently offer confirmed to fit your 2024 Ford F-350 with an 8' bed would be the Access Toolbox Edition Soft, Roll-Up Tonneau Cover # A61409. This is a soft roll-up cover which can fit toolboxes 19" - 21" wide.
expert reply by:
Kevin C
0
Product Page this Question was Asked From
Access Toolbox Edition Soft, Roll-Up Tonneau Cover
- Tonneau Cover
- Roll-Up - Soft
- Rack Compatible
- Tool Box Compatible
- Opens at Tailgate
- Tailgate Lock
- Standard Profile - Inside Bed Rails
- Vinyl
- Vinyl Grain
- Access
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Tonneau Cover for 2019 GMC Sierra 3500 With Toolbox
- Q&A: Availability of Powered Retractable Tonneau Cover for 2026 Chevy Silverado 3500 Long Bed
- Q&A: Can I Swap Out My AC Unit For One With A Higher BTU Rating?
- Q&A: Can I Use My 5th Wheel Trailer with the Pace Edwards Switchblade # PE66QJ on My 2022 Ford F-350?
- Q&A: Will the Pace-Edwards UltraGroove Manual or Electric Tonneau Covers Fit My 2021 GMC Sierra 3500?
- Q&A: Recommended Toolbox Compatible With The Access Toolbox Edition Soft, Roll-Up Tonneau Cover
- Q&A: Low Profile Toolbox and Tonneau Cover for 2020 Ford F-350 Long Bed
- Article: How to Install a Tonneau Cover
- Article: Most Popular Wheel Bearings
- Article: 5th Wheel to Gooseneck Adapters
- Article: Gooseneck to 5th Wheel Adapters
- Article: Converting Your RV Water Heater to Tankless
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
Jesse M.
2/3/2026
Hey Troy, how did the Access Toolbox Edition cover work out with your F-350 and toolbox setup? Your feedback could really help others looking for a similar fit.