Best Way To Remove 4-Flat Plug From Curt 4-Way Flat Mounting Bracket C42CR
Updated 07/18/2024 | Published 07/10/2024
Question:
What is the best way to remove a 4 way flat plug from the curt 4 way flat mounting bracket.
asked by: Dennis Z
Expert Reply:
Hello Dennis, thanks for reaching out. The best way to remove the 4-flat plug from the # C42CR bracket is basically the same way it went it. I would start by working the plug from side-to-side a bit to get it loose. Then press the plug out thru the back of the bracket. Try pressing with your thumb while working the plug side-to-side and it should come out with a little persuasion. If it is stuck in there real good you could maybe try some lubricant spray or WD40 to help move things along.
Product Page this Question was Asked From
Curt Mounting Bracket for 4-Pole Flat Trailer Connector
- Accessories and Parts
- Trailer Wiring
- Mounting Hardware
- Brackets
- 4 Flat
- CURT
more information >
Continue Researching
- Q&A: Will The Curt Mounting Bracket C42CR Match Up With The Curt No-Drill Bracket C57202?
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: My Trailer Hitch Doesn't Fit
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Does Tie Down Get Removed to Install Hitch on 2026 Lexus RX350
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Does Curt Trailer Wiring Harness Really Fit 2026 Toyota Grand Highlander without Tow Package
- Q&A: Recommended Hitch and Wiring Harness for a 2025 Mazda CX-5
- Q&A: Looking For Brackett For 4-Pin Flat Connector
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: The 5 Best Trailer Drop Hitches You Can Buy
Dennis Z.
7/17/2024
Thanks for the reply, figured it out, it came out just like you said. Thanks again.