Parts Needed to Convert 7k Axle Trailer with 38 inch Wheelbase to Slipper Springs
Updated 07/16/2024 | Published 06/30/2024
Products Featured in This Question
Question:
I am looking to change my double eye spring setup on my tandem axle deckover trailer to slipper springs. The axles need to have a 38 inch spread to the center of the axle and they are 7000lb capacity axles so I need springs to match. Axles are mounted with springs on top of the axle but I could change that if needed. Right now with the springs mounted over the axle I have 5.5 inches between the trailer frame and the u bolt plate. What parts do I need to swap this out?
asked by: Clark T
(click to enlarge)
Expert Reply:
Hey Clark, so for a tandem slipper spring hanger kit designed for 38 inch wheelbases is the part # HAP-105-205-01. Then for the slipper springs you'd need the part # e74SR and you'd be set.
For a u-bolt kit that is compatible with the 2 inch wide springs that I mentioned you'd then also need the part # APUBR-8.
Product Page this Question was Asked From
Dexter Tandem-Axle Trailer Hanger Kit for 2" Slipper Springs - 38" Axle Spacing
- Trailer Suspension Parts
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Slipper Springs - 2 Inch
- Tandem Axle
- Dexter
more information >
Continue Researching
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Slipper Spring Trailer Suspension System Review
- Q&A: Slipper Spring Hanger Positioning for 7,000 lb Tandem Axle
- Article: Double-Eye Trailer Suspension System Review
- Q&A: How to Determine Hanger Spacing for Tandem Axle Trailer Suspension with 26 Inch Springs
- Q&A: Replacement Bushing For Dexter 5-Leaf 10,000 Pound Axle Slipper Spring DX45QR
- Q&A: Orientation of Rear Hanger Installation on a Trailer with Double Eye Leaf Spring Suspension
- Q&A: Replacement Equalizers For 2-1/2" Slipper Springs Mounted To 10,000LB Dexter Axles
- Article: Most Popular Wheel Bearings
- Article: Trailer Wiring Diagrams
- Q&A: Specs for the Dexter 5-Leaf Slipper Spring W/ Flat End for 10K Axles
- Q&A: Difference Between Dexter Heavy-Duty Suspension Kit K71-448-00 & K71-359-00
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
Clark
7/16/2024
Those springs will not work with that hanger kit. The spring hangers have a 5/8 bolt hole the spring eyes are 9/16.