How Far Past The Edge Does The "Junior" Locking Steel Flush Door Latch # L1930 Extend?
Updated 06/18/2024 | Published 06/10/2024
Question:
Hello there. I am looking to replace the latch on my horse trailer but i dont see the measurements for the actual latch part of it. Mine is 1inch from the end of the mechanism to where it starts. Unfortunately, i wasnt able to upload my picture. Is there anywhere that i can find that info? Thank you in advance!!
asked by: Julia
Expert Reply:
As I see you were looking at the "Junior" Locking Steel Flush Door Latch # L1930 I can tell you the latch is going to stick past the edge of the latch by 3/8". This measurement is going to be past the edge of the cutout portion by 7/8" if that is where you are measuring from.
(click to enlarge)
Julia
6/18/2024
Does this measurement apply to L1883?
Product Page this Question was Asked From
"Junior" Locking Steel Flush Door Latch with Inside Release
- Trailer Door Latch
- Reversible
- Flush Latch
- Keyed Unique
- Built In Lock
- Bolt-On
- Steel
- Redline
more information >
Continue Researching
- Q&A: Replacement Tack Room Door Latch for CM Dakota Horse Trailer
- Q&A: Replacement For A Tri-Mark RO/ENR 1983/72130 RV Door Latch
- Q&A: How to Determine Correct Torque Setting for New Disc Brake Setup on Boat Trailer
- Q&A: Best Way To Haul Kayaks With Thule TracRac Ladder Rack
- Q&A: Is There a Roof Mount Bike Rack for Thule TracRac Ladder Rack
- Q&A: How to Fit Two Sea Kayaks and a Thule Cargo Box on a Honda CR-V with Yakima Roof Rack
- Q&A: Options for New Bearings for Trailer Hub with 30205 Bearings
- Article: How to Install E-Track in 3 Easy Steps
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Wiring Diagrams
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Raise Your Travel Trailer Height
- Article: How Do Portable Generators Work? A Beginner's Guide to Powering Your Life
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
Julia
6/18/2024
Hi Bud, thank you so much! This is exactly what i was looking for. Thanks again for your time.