Will The Yakima RuggedLine HD Mounting System Fit On A 2021 Toyota Highlander XLE
Updated 07/08/2024 | Published 05/19/2024
Products Featured in This Question
Question:
I have a 2021 Toyota hilander XLE will the Y43DJ fit and bolt up?
asked by: Chris
Expert Reply:
Hey Chris,
The Yakima RuggedLine HD Mounting System for LockNLoad Platform # Y43DJ is not compatible with a 2021 Toyota Highlander unfortunately. If you have flush mounted rails that run from front to back then you could go with the following components for a Rhino-Rack Platform roof rack instead:
Rhino-Rack Pioneer Platform Roof Tray # RR66AP
RCH Legs for Rhino-Rack Crossbars and Pioneer Platforms # RRRCH4
Custom RCP Fit Kit for 4 Rhino-Rack RC and RV Series Roof Rack Legs # RR66QT
Product Page this Question was Asked From
Yakima RuggedLine HD Mounting System for LockNLoad Platform
- Accessories and Parts
- Roof Rack
- Fit Kit
- Yakima
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Lowest Profile Roof Rack For 2018 GMC Yukon XL Denali With Factory Flush Rails
- Q&A: Can Yakima LockNLoad Platform Rack With RuggedLine HD Hold Roof Top Tent
- Q&A: Does the Yakima LockNLoad Platform Rack Block the Sunroof on a 2018 Jeep Grand Cherokee?
- Article: Rooftop Cargo Carriers
- Q&A: Best Roof Rack and Kayak Carrier for 2019 Subaru Outback Touring
- Q&A: Is Wind Noise An Issue With The Yakima LockNLoad Platform Rack
- Q&A: How to Wire Electric Brakes on a Tandem Axle Trailer
- Q&A: How do I Remove My Old Reliable HD-1206 Hubs so I can Replace them with New Ones?
- Article: Roof Rack Information
- Article: Anti-Rattle Devices
- Article: Stability Control for Heavy Duty Vehicles
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Strap a Bike To a Roof Rack
- Article: The 5 Best Trailer Drop Hitches You Can Buy
Troy F.
7/6/2024
Same question except for my 2013 Toyota Highlander Limited that comes with OEM roof rails.... except what if I take off the OEM roof rack can I then use this Yakima rugged line and install it using the factory mounts?