Dimensions of the Draw-Tite Hitch item # 41947

Updated 05/20/2024 | Published 05/18/2024

Question:

Looking for measurements on the 41947 receiver hitch. What is the bolt hole centerline spacing on the cross tube end plates i.e. horizontal and vertical hole spacing. Also what is the bolt hole centerline spacing measured vertically on the frame plates where the cross tube mounts?

asked by: S. C

Expert Reply:

I have attached an image of the Draw-Tite Hitch item # 41947 referenced in your question with a few dimensions labeled.

The distance between mounting holes, from the left side mounting bracket to the right side mounting bracket is 30-1/2". The distance between the mounting holes, center to center, is 3-1/2" for the closer of the two holes and 15-7/8" from the hole nearest the receiver to the rear bracket hole.

Additionally, the crosstube on the Draw-Tite item # 41947 can be adjusted along the frame brackets, so there are 3 possible answers to your question depending on where you set it. From the top of the bracket to the top of the receiver tube, there can be a distance of 6-5/8", 8-1/4", or 10-1/4".

expert reply by: Jerred H