Is There a Socket Adapter for Drill for Replacement Manual Crank Handle LC119226
Updated 05/13/2024 | Published 05/12/2024
Question:
I am looking for a socket with the slotted configuration for a Lippert 119226 electric stabilizer to fit into my drill so that I can use the drill to put the stabilizers down instead of the manual crank in case of a power outage. Do you have such a socket to fit a drill?
asked by: Ron T
Expert Reply:
Hey Ron, The end of the Replacement Manual Crank Handle # LC119226 is a slotted cylinder which means there isn't a socket that would work as a substitute. Unless you wanted to sacrifice a socket that you have now. You'd need to find one that's right diameter and then use a grinder to cut some slots in the sides.
Product Page this Question was Asked From
Replacement Manual Crank Handle for Lippert 5th Wheel RV Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Handles and Cranks
- Sidewind
- Lippert
more information >
Continue Researching
- Q&A: Looking for Hand Crank Replacement for Thule Crown Awning
- Q&A: Need Dimensions For Manual Override Crank With Slotted Head
- Q&A: Replacement Parts for Jack System On 2008 Cameo by Carriage 5th Wheel
- Q&A: Replacement Crank Handle For the Lippert Spare Tire Winch with Offset Cable
- Q&A: Replacement Landing Gear Motor for a 8532-07 Motor
- Q&A: Availability of Lippert SolidStep For 25" Entry Height and 24" Doorway
- Q&A: Faster Motor Replacement for Venture M9000PK Landing Gear
- Article: Cleaning Your RV Gray Water Tank in 5 Easy Steps
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Article: Stability Control for Heavy Duty Vehicles
- Article: Best RV Roof Vents
- Article: Trailer Wiring Diagrams
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?