Do You Have a Replacement Wheel Hub For a Discontinued Harbor Freight Boat Trailer?
Updated 05/14/2024 | Published 05/12/2024
Products Featured in This Question
Question:
Hello, I’m looking for a direct hub and wheel replacement for the discontinued harbor freight boat trailer.
asked by: Tim S
0
Expert Reply:
Unfortunately Tim, I have no way to know for sure what size spindle you have on your discontinued Harbor Freight boat trailer. If you can provide me with the measurements off your spindle as seen in the image below I can see if we have a hub which will fit but as is most common with Harbor Freight trailers I have seen you are most likely going to need 2 new Spindles # TRU64FR and Hubs # AKIHUB-545-35-G-EZ-K.
expert reply by:
Bud M
0
Spindle Measurement Points
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
#84 Spindle for 3,500-lb Trailer Axles - 1-3/4" Diameter
- Trailer Spindles
- Standard Spindle
- Without Flange
- L68149
- 1-3/4 Inch Diameter
- Round
- For 3500 lb Axle
- TruRyde
more information >
Continue Researching
- Q&A: Which Caliper Should Be Used With The Dexter 9-3/4" Hub-and-Rotor Assembly DX82UR?
- Q&A: Replacement Hub/Rotor Assembly for a Dexter Boat Trailer Axle DX67HR
- Q&A: What Inner and Outer Bearings Does 3,500 lb Axle Disc Brake Kit Use
- Q&A: What Size and Thread Pitch is the CE Smith Tapered Spindle Axle CES98WR?
- Q&A: How to Wire the Dexter Electric Over Hydraulic Trailer Brake Actuator
- Q&A: Do Trailer Spindles Just Weld to End of Axle
- Q&A: Troubleshooting Dexter Electric Over Hydraulic Brake Actuator Not Applying Pressure to Brakes
- Article: Most Popular Wheel Bearings
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Troubleshooting 4 and 5-Way Wiring Installations