Are The Lights on The Identification Light Kit # MCL22RK3B Going To Stick Out Like In The Images?
Updated 05/08/2024 | Published 05/07/2024
Question:
The pictures and video shows these as sticking out Not flush. Then one picture shows them flush. Which is it? I do not want them sticking out. Thanks
asked by: Ted B
0
Expert Reply:
Most of the pictures for the Identification Light Kit # MCL22RK3B do show the lights sticking out of the grommets as they are simply not pushed in. The lights will end up sitting in further but not quite flush as seen in the image below.
expert reply by:
Bud M
0
Identification Light Kit # MCL22RK3B
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Identification Light Kit for Trailers over 80" Wide - Submersible - 3 LEDs - Red
- Trailer Lights
- Clearance Lights
- Marker
- Light Bar
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 3/4 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Q&A: Replacement 20575D15 Tires for Utility Trailer
- Q&A: Solution For Needing Replacement Solenoid of Roadmaster Battery Disconnect for Towed Vehicle
- Q&A: Can A-60 Actuator be Locked
- Q&A: Can Round U-Bolts Be Used On a Square Axle Tube?
- Article: Trailer Lighting Requirements
- Q&A: Will the Brake Buddy Battery Maintainer work with Battery Disconnect RM-766
- Q&A: Why Disconnect Battery to Flat Tow Vehicle Behind Motorhome
- Q&A: Blue Ox Base Plates & Wiring For Flat Towing 2023 Chevy Equinox Behind Motorhome
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Ram Trailer Tow Prep Package
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: 7 Common Questions Everyone Has About Trailer Tires