How to Install the ThinLine Mini LED Side Marker or Clearance Light w/ Bracket MCL-91AK?
Updated 04/26/2024 | Published 04/25/2024
Question:
Ive been looking at your LED submersible amber trailer lights and have a question about instalation. The Incandescent light I am replacing has only one wire lead. Is that the hot positive lead and then it grounds to the frame? I could use some help with the wiring.
asked by: Thomas C
Expert Reply:
Yes, that is correct. To install the ThinLine Mini LED Side Marker or Clearance Light w/ Bracket item # MCL-91AK, you would run the power for the light to the single wire and then if it won't be attached directly to the frame, you will run a ground wire to the frame and then to the mounting hardware of the bracket as it is designed to ground through it.
Product Page this Question was Asked From
ThinLine Mini LED Side Marker or Clearance Light w/ Bracket - Submersible - 3 DIodes - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 2-1/2L x 1-3/16W Inch
- Amber
- Optronics
more information >
Continue Researching
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Q&A: Best Replacement for a Wesbar Tail Light 271594
- Q&A: LED Lights for 1991 Ranger Boat Trailer
- Q&A: Will The etrailer Hub AKIHUB-545-35-G-EZ-K Fit A 10 Inch Wheel?
- Q&A: Options For Replacing An Elixir ELX-60 Converter
- Q&A: Best Replacement Actuator for a Titan Aero-6000
- Q&A: What Microwave Will Replace My Advent P90D23AL-G1-FR03 MW912B?
- Q&A: Hasp Dimension of ABS5FR
- Article: How to Measure a Trailer Axle
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop
- Article: The 5 Best Trailer Drop Hitches You Can Buy