Replacement for Dexter Axle 7056-00 Entry Door Seal
Updated 05/17/2024 | Published 04/04/2024 >
Products Featured in This Question
Question:
Hi. I have an entry door by Dexter that is missing some of the seal at the bottom. It’s a hollow self adhesive D seal with 3 ribs, 3/8x5/8. Tried some seal that seemed ti match, but it was firmer and kept the side of the door off the side seal. Dexter says their part number is 7056-00, but they don’t sell it. They referred me to McMasters but they don’t have it either. Appears to be a product of Central Rubber Extrusions of Illinois but they also don’t retail. Looking for 5 feet. Do you carry this seal or know where I might find it?
asked by: Jeff
Expert Reply:
Hey Jeff, thanks for reaching out!
I have 3 different seals that are potential candidates but we unfortunately don't have the 7056-00 seal you're looing for:
- Rubber Ribbed Wide Seal # SR82FR
- Rubber Medium Half Round Seal # SR35ZR
- Rubber Rectangular Seal # SR25FR
The Ribbed Wide Seal looks to match the closest in design, but it's solid and rubber whereas the 7056-00 looks to be more foam so it will compress easier which is why I included the half round and rectangular seals for your reference.

Product Page this Question was Asked From
Rubber Ribbed Wide Seal for RV and Trailer Doors - Stick On - 15' Long x 5/16" Tall
- Trailer Door Parts
- Seals
- Ribbed Seals
- 9/16 Inch Tall
- Stick-On
- 5/16 Inch Wide
- 15 Foot Long
- Rubber
- Steele Rubber
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Lippert Replacement Nason Hydraulic High Pressure Switch with All Weather Connector - 2,150 psi
- Shop: Kenda ST235/75R15 Radial Off-Road Trailer Tire - Load Range D
- Shop: Trimax Universal Anti-Rattle Clamp for Class III and IV Trailer Hitches
- Shop: Trimax Universal Anti-Rattle Clamp for Class V Trailer Hitches
- Q&A: Slide Topper Awning for RV with Flange Measurements of 156 inches
- Shop: Trailer Hitch
- Shop: Trailair Rota-Flex 5th Wheel Pin Box - Lippert 1621 or 1621HD - 18,000 lbs
- Shop: B&W Anti-Rattle Clamp for 2" Hitch Receivers
- Shop: Curt Rota-Flex 5th Wheel Pin Box - Lippert 1116 - 19,000 lbs
- Q&A: Replacement Motor For Kwikee 32 Series Step With Kwikee 9551 Motor
- Shop: Roof Rack
- Q&A: Do Rhino-Rack Roof Rack & Kayak Carrier Fit 2017 Jeep Wrangler JKU Hard Top
- Q&A: Will the Rhino-Rack SG Roof Rack Work With a Thule or Yakima Roof Box
- Search Results: quick link
- Article: How to Measure for Trailer Hitch Drop
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Q&A: Replacement Propane Gas Detector for an Atwood 31013 Propane Detector
- Q&A: Replacement Brake Assembly Parts for 2800 lbs Philips/Dexter Axle with 1-1/4 Inch Deep Hubs
- Q&A: Determining if Solera Slide-Topper Can be Installed on Slide-Out with Electric Awning
Jeff
4/5/2024
Thanks for the reply. I’ve tried what looked like a similar seal, but it turned out to be much firmer and kept the bottom of the side of the door off the side seal. I’m a little hesitant to spend $XX+ on something that may or may not work, but if I can’t find the original seal the factory uses I’ll give it a shot. I’m kind of surprised it isn’t easy to find OE seals for Dexter’s doors. Anyway thanks again for the help.