Replacement Clearance Light that Has 14 inches Between Bolt Holes
Published 03/21/2024
Question:
looking for thin trailer tail lights @ 1.3 inches wide 14 center to center on holes thanks Mario i can e-mail you pictures if needed
asked by: Mario C
0
Expert Reply:
Hey Mario, we have the Optronics clearance light # MCL70RB that is very close to the dimensions you mentioned. It has mounting holes that are 14-1/8 inches apart and it is 1-3/8 inches wide. Feel free to email me back with the pictures you have if this isn't what you had in mind.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
UltraThin ID Light Bar for Trailers over 80" Wide - Submersible - 3 Diodes - Red Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- ID Bar
- Surface Mount
- Submersible Lights
- LED Light
- 15L x 1-1/2W Inch
- Red
- Optronics
more information >
Continue Researching
- Article: Trailer Lighting Requirements
- Q&A: Parts Needed to Install Curt RVi Series Shadow 2 Flat Tow Brake System on 2025 Ford Maverick Hybrid
- Article: Trailer Wiring Diagrams
- Q&A: Best Replacement for a Wesbar Tail Light 271594
- Q&A: Highest Capacity Electric Brakes for a 4 Bolt Brake Mounting Flange
- Q&A: Trailer Spindles to Fit Inner Bearing L68149 and Outer Bearing LM67048
- Q&A: Can a 5.30-12 Size Tire be Replaced with a ST145/R12 Size Tire
- Q&A: Replacement Trailer Grease Seal for an NOK AD2527E Seal on a Boat Mate Trailer
- Q&A: What Gauge Wire Is Needed To Run Charge Line for Battery From Truck to Trailer
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: 7 Common Questions Everyone Has About Trailer Tires