Does Replacing Turn Signal on Motorhome with LEDs Require Installing Load Resistors
Published 01/16/2024
Question:
I plan on using two of these LED turn indicator lights to replace the current incandescent ones on my motorhome. Is it as simple as clipping the wires, connecting the 3-way pigtail A47PB, and plugging them together? Ive heard stories of how going from standard flasher bulbs to LED ones can cause hyperflashinginch and can sometimes require some special relay or a load-resistor kit.
asked by: Lester W
Expert Reply:
When replacing an incandescent turn signal circuit bulb on a vehicle with an LED you would need to install load resistors or you can go with the easier solution of replacing the thermal flasher unit that controls the blinkers with a digital one. I did this on a vehicle years ago and it's much easier than trying to find the correct load resistor. We do not carry digital flasher units though so you would need to source that elsewhere.
Product Page this Question was Asked From
Optronics LED Tail Light w/ Flange - Parking and Turn Signal - Submersible - Round - Amber
- Trailer Lights
- Tail Lights
- Marker
- Turn
- Round
- Surface Mount
- Submersible Lights
- LED Light
- 4 Inch Diameter
- Amber
- Optronics
more information >
Continue Researching
- Q&A: Replacement for a Sharp Carousel Microwave R-820BK-F
- Article: Trailer Lighting Requirements
- Q&A: Greystone Built-in Microwave 324-000106 Not Heating Up Food
- Q&A: Replacement Microwave for a Sharp R820BK RV Microwave
- Q&A: Recommended Replacement For A Sharp Carousel RV Microwave Model # R-820BK-F
- Q&A: Recommended Agricultural Hub w/ a 4 on 5 Bolt Pattern
- Q&A: Dimensions of the Mounting Holes of the LED Trailer Stop/Turn/Tail Light # STL43RBX
- Q&A: Replacment Slide-Out Motor For Power Gear 522176
- Article: 4 Times You'll Regret Buying the Wrong Bike Rack
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Thank you!