Availability Of 3" Wide 4' Long Aluminum Hinge With A 3/8" Pin

Question

Question:

looking for an aluminum hinge 3 W x 4 L x 1/4 Thick with 3/8 pin quantity 5

asked by: David G

0

Expert Reply:

It appears we do not carry a hinge that will fit those parameters exactly. We do offer a few 3" wide continuous hinges with a 3/8" pin like the # MA94ZR. This is a stainless steel hinge that measures 6' long overall. Unfortunately we do not offer anything in aluminum that will be 4' long. They will all be 6' or longer. So the # MA94ZR will be the closest thing that we offer.

expert reply by: Jesse M

0

Answer 1

Hey Don, thanks for reaching out. We do have 6' long aluminum hinges, but nothing 6" wide. In that size a 4" wide would be our widest. Take a look at the following: - 4" Wide Continuous Hinge - 6' Long - 3/8" Pin Diameter…

view full answer...

Answer 2

We only have one piano hinge that is either 4" or 6" wide and constructed of either stainless steel or aluminum. That is the 4" Wide Continuous Hinge #MA38JR which is made of aluminum and 72" long with a 3/8" pin diameter. We…

view full answer...

Answer 3

Hey Tim welcome back! Your ARH15AACBL2 GE AC unit has the old 410a refrigerant in it so the GE Appliances item #GE64FR you were looking at isn't going to work as a replacement. The EPA mandated R32 refrigerant has been used in all new AC's…

view full answer...

Answer 4

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Answer 5

Marlboro does not list weight capacities for either the #MA75VR or the #MA45VR that you referenced. They state it will be up to the installer to determine the appropriate weight capacity. We also do not have this in a 3 foot length.

view full answer...

Answer 6

The best option we have for you is the Continuous Stainless Steel Hinge part #SH300. This hinge is 6' long, 3" wide, and has 1" long knuckles. The overall length of the hinge will be an exact fit but the width will be about 1/4"…

view full answer...

Answer 7

You will need the Repair Kit #RM910003-85 for your Roadmaster Falcon All Terrain, Non-Binding Tow Bar #RM-522. You should not have any need to replace the Inner Arm #910021-65 or Latches #910003-45 unless there is very noticeable wear on these…

view full answer...

Answer 8

The thickness of the flat/plate section where the lugnuts mount on the Taskmaster Solid Center Wheel w/ -0.19 Offset - 17-1/2" x 6-3/4" Rim #TA45ZR is .4488 of an inch. Included is a video overview with additional information.

view full answer...

Answer 9

Hey Randy, thanks for reaching out! The Taskmaster Solid Center Wheel w/ -0.31 Offset #1750865SP1125 is a standard 17-1/2" wheel with an 8 on 6-1/2" bolt pattern and fits over 5/8" studs so it sounds like it will work for your…

view full answer...

Availability Of 3" Wide 4' Long Aluminum Hinge With A 3/8" Pin

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching