Mounting Bracket Dimensions for the Fulton Round Snap-Ring Swivel Marine Jack # FTJ120W0301
Published 04/11/2014
Question:
what are the lenth and width of the holes i need 51/2inch side to side middle to middle and 3inch up and down between holes
asked by: Emmett B
Expert Reply:
I believe the Fulton Round, Snap-Ring Swivel Marine Jack # FTJ120W0301 you referenced would work for you. I went out into our warehouse and pulled one to measure the dimensions of the mounting flange and I believe it would work for you since you said you needed 3 inches up and down between the mounting holes.
Since I was a little confused about the other measurements you said you needed I took a bunch and put them on a picture that I attached for you to check out and see if it would be compatible for you.
Product Page this Question was Asked From
Fulton Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 10" Lift - Zinc - 1.2K
- Trailer Jack
- Boat Trailer
- Utility Trailer
- Side-Mount Jacks
- Swivel Jacks
- Sidewind Jack
- 1001 - 2000 lbs
- Manual Jack
- 10 Inch Lift
- Weld-On
- With Wheel
- Fulton
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Jack for Bulldog Model 130 Marine Jack
- Q&A: Recommendation to Replace Shelby 5756A Trailer Jack
- Q&A: Upgrade to Replace Fulton Boat Trailer Jack FTJ120W0301
- Q&A: Replacement for Shelby Industries Model 5756 Boat jack
- Q&A: Cost Effective Weld-On Trailer Jack With A Wheel
- Q&A: Jack Recommendation for a Triton Boat Trailer
- Q&A: Is there a Higher Rated Fulton Jack that Uses the Same Swivel Mount as My TJ120W0301?
- Article: Best Boat Trailer Jacks
- Article: Trailer Maintenance Schedule
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Trailer Lighting Requirements
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Tire Sizing
- Article: How to Tell the Weight Rating of a Trailer Axle