What Circuit to Tap Into to Install the Hopkins Trailblazer Electronic Deer Alert # HM27512VA
Published 04/10/2014
Question:
I had one once installed and it was connected to the battery and the other wire to a fuse in the fuse box. I have a different car now and want to install another one. Can you tell me which fuse can be used? I did have it connected to a 20 amp fuse in my previous car.
asked by: Pat M
Expert Reply:
Basically you will want to look for a circuit that sees 12 volts when the vehicle is running an none when the vehicle is off. Common circuits are radio, ignition, traction control switch, power antenna.
Another way to wire the Hopkins Trailblazer Electronic Deer Alert # HM27512VA would be to wire it to the high beams circuit so that it activates when you turn your brights on.
Product Page this Question was Asked From
Hopkins Trailblazer Electronic Deer Alert
- Backup Camera
- Sensor and Alert Systems
- Hardwired
- Obstacle Alerts
- Hopkins
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Video: How to Set Up Your Hopkins Trailblazer Electronic Deer Alert on a 2013 Chevrolet Cruze
- Shop: Hopkins Trailblazer Electronic Deer Alert
- Q&A: Is Hopkins Trailblazer Electronic Deer Alert Audible to Humans
- Shop: ATO/ATC Dual Fuse Tap - 10 Amp Main - 5 Amp Added
- Video: A Closer Look at the Hopkins Trailblazer Electronic Deer Alert
- Video: The Low-Down on the Hopkins Trailblazer Electronic Deer Alert
- Q&A: Troubleshooting No Running Lights on Trailer but Turn Signals and Brake Lights Work
- Q&A: Can a Backup Camera Be Used at the Back of an RV or Trailer
- Q&A: What Does the Hopkins Electronic Deer Alert Sound Like
- Article: Calculating Portable Generator Power Needs
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Trailer Hitch Fit for a 2019 Mazda CX-5 Grand Touring Reserve
- Q&A: Trailer Hitch Receiver Fit For 2019 Mazda CX-5 Grand Touring
- Q&A: How Heavy of a Trailer Can a 2018 Mazda CX-5 Tow