Will The MORryde RV Generator Slide Out Tray # MR79RR Allow For Westinghouse iGen4500 Generator?

Updated 11/26/2023 | Published 11/21/2023

Products Featured in This Question

MORryde RV Generator Slide Out Tray - 25-3/4" x 26-1/4" - 100 Percent Extension - 300 lbs

(278)

$343.40

MORryde RV Cargo Slide Tray - 36" x 26" - 1 Way Slide - 60 Percent Extension - 800 lbs

(1415)

$575.84

Question:

Will the iGen4500 fit inside this slide out tray. And what would the height of the IGen45400 be sitting in the tray [in order to see if compartment height is sufficient

asked by: Donald G

Expert Reply:

According to Westinghouse the iGen4500 is 24.5" long, 17.5" wide and 20" tall. This may not fit inside the MORryde RV Generator Slide Out Tray # MR79RR which has an internal dimension of 24-1/4" wide by 24" deep inside the tray. Since the dimensions listed are measured at the widest point of the generator and the tray is only 2-3/4" deep it may still fit. You would need to measure the widest points on the generator at the 2-3/4" height to verify if it will fit into the tray.

For the overall height with the generator the bottom of the tray is going to sit 2-1/2" above the floor which would put the generator at 22-1/2" tall if it will sit all the way into the tray.

If the generator is too large for the tray you can opt for the MORryde RV Cargo Sliding Tray # MR37FR which has a tray 34-1/4" long by 22-7/8" wide.

expert reply by: Bud M