Replacement Surge Brake Actuator For a Painted Trailer With UFP A-60 Actuator
Published 11/17/2023 >
Products Featured in This Question
Question:
I have a steel painted trailer with a UFP A60 brake , no bolt on! Will the Dexter you show fit it?
asked by: Donald R
Expert Reply:
To determine if the Dexter DX7.5 Drop-N-Go Brake Actuator # 099-175-20 will work in place of your current brake actuator you will need to verify you have enough 3" wide channel to mount the actuator. This actuator is a little shorter so depending on the length of the tongue and your payload area or boat as it may not allow you to use the other actuator.
We do have the Replacement Inner Member # DX39FR you can use to basically give you a new actuator.
Product Page this Question was Asked From
Dexter DX7.5 Drop-N-Go Brake Actuator - Disc Brakes - 2" Ball - Zinc Plated - 7,500 lbs
- Brake Actuator
- Surge Brake Actuator
- Boat Trailer
- Construction Trailer
- Farm Trailer
- Travel Trailer
- Utility Trailer
- Bolt-On
- 7500 lbs GTW
- 2 Inch Ball Coupler
- 3 Inch Channel Tongue
- Disc Brakes
- Electric Lockout
- Dexter
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Shop: Trailer Wheel Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Shop: Vehicle Tow Bar Wiring
- Search Results: bleeding hydraulic brakes
- Shop: Dexter Premier Disc Brake Kit - 10" Hub/Rotor - 5 on 4-1/2 - Dacromet - 3,500 lbs
- Shop: Replacement Inner Member for Dexter DX7.5L Actuator - Single Axle w/ Disc - 2" Ball - 7,500 lbs
- Shop: Curt Tow Bar 7-Way to 6-Way Coiled Adapter Cord w/ 6-Way Socket - 7' Long
- Shop: DeeMaxx Trailer Idler Hub for 3,500-lb Axles - 5 on 4-1/2 - Galvanized
- Q&A: Will Replacement Inner Member DX39FR Replace UFP A-60 Actuator Part
- Shop: Trailer Wiring
- Search Results: ufp a 60 actuator
- Search Results: trailer brakes
- Search Results: disk brake conversion
- Shop: Emergency Break Away Cable Repair Kit for Dexter Axle A-60 Brake Actuators
- Shop: Bearing Buddy Bearing Protectors - Model 1980A-SS w/ Auto Check - Stainless Steel - Qty 2
- Q&A: What Actuator Will Replace My UFP A-60
- Q&A: Disc Brake Kit Recommendation for 3,500 lb Axle and 5 on 4-1/2" Bolt Pattern Idler Hub
- Q&A: Inner Member Replacement for Dexter UFP A-60 Brake Actuator
- Q&A: Parts Needed to Convert Trailer to Surge Disc with Welded on Atwood Actuator and 3,500 lb Axles
- Q&A: Replacement Master Cylinder for Dexter DX7.5L A-60XL Brake Actuator w Electric Lockout
- Shop: Roof Rack
- Q&A: Tie Down Model 70 Surge Brake Actuator Replacement Recommendation
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best Boat Trailer Jacks
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub

