Mounting Hole Spacing And Cutou Hole Requirement For The Roadmaster 4-Wire Connector
Updated 10/16/2023 | Published 10/06/2023
Question:
Im replacing a broken unit. What is the distance between the center of the mounting holes and the diameter of the round part just behind the flat mounting surface? it would slide thru existing hole thx
asked by: Larry
0
Expert Reply:
The RoadMaster 4-Wire Connector # RM-910030-1 has a 1-3/4" center to center spacing for the mounting holes and would require a at minimum a 7/8" wide hole to fit the body of the connector through.
expert reply by:
Kevin C
0
RM-910030-1 Mounting Hole Spacing
(click to enlarge)
(click to enlarge)
RM-910030-1 Dimensions
(click to enlarge)
(click to enlarge)
FVK1020-19 Dimensions
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
RoadMaster 4-Wire Connector - Vehicle End
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- 4 Round
- Plug Only
- Roadmaster
more information >
Continue Researching
- Q&A: Where is the Serial Number Located on a Roadmaster Tow Dolly
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: Do I Need a Fuse Bypass Switch and Breakaway Kit to Flat Tow My 2014 Honda CR-V
- Q&A: Solution for Needing New Power Cables for Brake Buddy 3
- Q&A: How To Wire Brake Buddy Battery Charger 39339
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Flat Towing Package for 2012-2014 Honda CR-V
- Q&A: Where is Fuse that Needs to be Removed to Flat Tow 2014 Honda CR-V
- Q&A: Trailer Wiring Socket Recommendation for a 4-Pole Round Trailer Connector
- Q&A: Are Check Valves Still Needed With Demco Vacuum Connection Tee Fitting
- Article: Trailer Wiring Diagrams
- Article: How (and Where) to Connect an RV Propane Grill