Where Does Red Wire go For Optronics Light MCL22RK3B
Updated 08/28/2023 | Published 08/27/2023
Question:
My trailer has two brake light circuits, one L and one R. Your product has absolutely no instructions, disappointed after spending approximately $xx for this item. How do I connect the Red wire from the LED lights?
asked by: John
0
Expert Reply:
That's a very good question, so I reached out directly to the manufacturer, Optronics, about where the red wire goes on the Identification Light Kit # MCL22RK3B. They responded by saying you will connect the red wire to the stop/turn signal wire on either the left or right.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Identification Light Kit for Trailers over 80" Wide - Submersible - 3 LEDs - Red
- Trailer Lights
- Clearance Lights
- Marker
- Light Bar
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 3/4 Inch Diameter
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement 20575D15 Tires for Utility Trailer
- Q&A: Solution For Needing Replacement Solenoid of Roadmaster Battery Disconnect for Towed Vehicle
- Q&A: Can A-60 Actuator be Locked
- Q&A: Can Round U-Bolts Be Used On a Square Axle Tube?
- Q&A: Why Disconnect Battery to Flat Tow Vehicle Behind Motorhome
- Q&A: Will the Brake Buddy Battery Maintainer work with Battery Disconnect RM-766
- Q&A: Blue Ox Base Plates & Wiring For Flat Towing 2023 Chevy Equinox Behind Motorhome
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Ram Trailer Tow Prep Package
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: 7 Common Questions Everyone Has About Trailer Tires