Can The E-Track e85VR Be Installed Directly To Aluminum?
Updated 08/28/2023 | Published 08/25/2023
Products Featured in This Question
Question:
Is the powder coating on this E_Track sufficient to avoid galvanic corrosion of dissimilar metals when mounting this on an aluminum trailer? Thank you.
asked by: Luis
0
Expert Reply:
While the powder coating on the E-track # e85VR is durable, the coating by itself will not be sufficient to prevent galvanic corrosion when installing to an aluminum floor or wall. We recommend putting some kind of layer between the e-track and the aluminum. This "layer" could be made of almost any material, such as wood, rubber, or plastic.
expert reply by:
Jesse M
0
Product Page this Question was Asked From
etrailer Horizontal E Track - Black Powder Coated Steel - 2,000 lbs - 4' Long
- E Track
- E Track Rails
- Horizontal
- 4-7/8 Inch Wide
- 2000 lbs
- 4 Feet Long
- etrailer
more information >
Continue Researching
- Q&A: Recommended E Track Rails for Adding Extra Tie Downs to a Car Hauler
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: Can E-Track be Driven Over and be Used to Secure Vehicle Tire To
- Q&A: Troubleshooting Voltage Drop to Trailer Brake Assemblies
- Q&A: Where is etrailer.com From
- Q&A: Determining Spacing of E-Tracks for Vehicle Transport
- Q&A: Replacement Parts for Fulton F2 Dual Wheel Trailer Jack
- Q&A: Replacement Cover for Trailer 4-Way Connector
- Article: RV Pre-Departure Checklist
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: The Best Towing Mirrors
- Article: Trailer Wiring Diagrams
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV