Will The Aluminum Hi-Spec Series 6 Trailer Wheel # AM22651 Require Special Center Cap or Lug Nuts?

Question

Question:

I assume there is no need for a center cap with this wheel design? Also, takes standard 60 degree 1/2-20 Lug nuts ? Can I go with basic lug nuts as they are not visible anyhow ?

asked by: Bob

0

Expert Reply:

The Aluminum Hi-Spec Series 6 Trailer Wheel # AM22651 does include its own center cap. So you will not need to use any other cap. The wheel is designed to work with 1/2-20 60-degree lug nuts and you can use a basic Lug Nut # CE11051.

expert reply by: Bud M

0

Answer 1

The difference is the size wheel each would fit. Center Cap #AM90092 is designed for 16 inch diameter wheels with 6 or 8 hole bolt patterns. Center Cap #AM90091 is designed for 15 inch wheels with a 5 hole bolt pattern.

view full answer...

Answer 2

The Americana Trailer Wheel Center Cap - Chrome #AM90091 is designed to fit 15 inch diameter wheels like #AM20455 that have a 5-hole bolt pattern and 3.19 inch pilot diameter. If this matches the wheels you have on your 2008 Starcraft Trailer, then…

view full answer...

Answer 3

The center cap on a trailer wheel like the Aluminum Hi-Spec Series 6 Trailer Wheel - 15" x 6" Rim - 5 on 4-1/2 #AM22651 will have a screw on the front to remove without removing the tire or wheel. You actually need to remove the cap…

view full answer...

Answer 4

I like the chrome wheel cap #AM90091 better with it, but it is really a personal preference. The Stainless steel #AM90175 would also work great for your #AM20537 Dexstar silver wheel.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Will The Aluminum Hi-Spec Series 6 Trailer Wheel # AM22651 Require Special Center Cap or Lug Nuts?

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching