Correct Welding Material For Installing Buyers Products 2" Forged SAE Trailer King Pin
Published 08/22/2023
Question:
Do I use 7018 or .045 flux core to weld king pin
asked by: David V
Helpful Expert Reply:
It looks like you need either a 5/32" low hydrogen welding rod or .045" low carbon wire in order to properly install the Buyers Products 2" Forged SAE Trailer King Pin with 1/2" Bolster Plate # 337KP20050.
I'm not going to pretend to start to know a thing about welding, but an experienced welder who has done this type of work before will know which option is best for you. If you haven't done something like this before then I highly recommend having a professional check the work when you're done because king pins like this are only used in heavy duty applications.
Product Page this Question was Asked From
Buyers Products 2" Forged SAE Trailer King Pin with 1/2" Bolster Plate - Weld On
- 5th Wheel Pin Box
- King Pin Only
- Buyers Products
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Are B and W Companion and Patriot Heads Interchangeable
- Q&A: Parts Needed To Pull A Gooseneck Trailer Behind a 2007 Kenworth T800
- Q&A: Replacement Hub Drum for Hayes 8k Trailer Axle
- Q&A: Height of Dexter Trailer Hub DX22XR
- Q&A: Bearing Kit and Hub Recommendation for a Dexter P-12 SLR Axle
- Q&A: Trailer Hitch for Carrying Bike Rack with 2020 Hyundai Elantra
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)