Recommended Mounting Bracket for a Fulton F2 Trailer Jack
Updated 08/22/2023 | Published 08/21/2023
Question:
I have a F2® Marine Trailer Jack, 1,600 lbs. Lift Capacity which was from my previous trailer which had a 4inch channel and my current trailer is 5. Can I purchase a mounting plate which will accommodate a 5inch channel? I would like to be able to utilize my existing jack. On the fulton site, it says: Available in bolt-on and weld-on versions for up to 5inch tongues. It is item 1 on the parts list. Thanks for your help.
asked by: Bob
Expert Reply:
What you're looking for is the Fulton Adapter Kit # F500320. All the mounts according to Fulton will fit up to a 5" trailer frame so you'll be all set.
Product Page this Question was Asked From
Fulton Adapter Kit - Weld-On XP Jack Mount to F2 Swing-Up Trailer Jack for 3" x 4" Frames
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Mounting Hardware
- Plates
- Fulton
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Trailer Jacks for Existing Fulton Weld On Mounting Bracket
- Q&A: Trailer Jack for Use in Off Road Conditions
- Q&A: Replacement Jack that Fits the Weld On Mounting Bracket for Fulton F2 Jacks
- Q&A: Replacement Swivel Jack for 2005 EZ Loader Boat Trailer
- Q&A: Replacement For Dometic AC 59516.331
- Q&A: Recommended Replacement Weld on Trailer Jack for a Phoenix Boat
- Q&A: Looking For A Replacement Actuator for ufp 34043
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Best Boat Trailer Jacks
- Article: Boat Trailer Guides: Which are the Best?
- Article: How to Measure a Trailer Axle