Inner Tube Dimensions Of The etrailer Stabilizer Jack # TJ01RT
Published 08/07/2023 >
Question:
Hello- Looking for the internal measurements that slides inside the housing of the foot portion of the jack TJ01RT. I have a 1998 Jayco Eagle 12UDK and one of the internal feet fell off. They are welded on and I think this jack foot might fit, but need the internal measurements to be sure. If not, ill have to have the entire assembly cut out and purchase a new one and have it welded on. Appreciate it!
asked by: Rob O
0
Expert Reply:
The internal tube (drop leg) of the etrailer Stabilizer Jack # TJ01RT is 1-7/16" x 1-1/2".
expert reply by:
Kevin C
0
Product Page this Question was Asked From
Stabilizer Jack - 6-1/4" Drop Leg Travel - 18" - 650 lbs - Qty 1
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- 0 - 1000 lbs
- Manual Jack
- Bolt-On
- Weld-On
- 1 Jack
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How Thick of a Panel Will Fit Into # PF38FR?
- Q&A: Do K-Source Tow Mirrors # KS48NQ Fit 2026 Toyota Tundra TRD
- Q&A: Recommended Voyager WiSight Camera for a New Trailer Without Pre-Wire
- Article: How to Install E-Track in 3 Easy Steps
- Article: How to Replace or Install an RV Roof Vent
- Q&A: Recommended Stabilizers For Ramp Door On Toyhauler
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Q&A: Can Weld-On A-Frame Trailer Coupler be Replaced with a Bolt-On Coupler
- Q&A: Can Demco Coupler # DM14793-52 Have Holes Drilled for Installing Coupler
- Q&A: Can The etrailer Sleeve-Lock A-Frame Trailer Coupler # CA-5196-B Be Bolted To The Trailer Tongue
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)




