What Size Butt Connectors Are Needed for the Lippert Flow Max Fluid Pump?
Updated 07/17/2023 | Published 07/15/2023
Products Featured in This Question
Question:
I am replacing my water pump with a LC689052 pump which heat shrink butt connectors do I need?
asked by: Douglas S
0
Expert Reply:
It's going to depend on how far you are needing to run your wires as the farther you run your wires you're going to get a power drop.
If you're planning on running the wires no more than 25' which is what I assume, then you'd to use at least 16 gauge wire and would need the 16-14 Gauge Butt Connector # 05731-5.
If you're looking to run the wire farther than 70', you'd need to beef your wire to at least 12 gauge and would then need # DW05745-5.
expert reply by:
Bryce D
0
Product Page this Question was Asked From
16-14 Gauge Butt Connector - 5 Pack
- Wiring
- Wire Connectors
- Butt Connectors
- 14 Gauge
- 16 Gauge
- Deka
more information >
Continue Researching
- Q&A: Best Rear Suspension Enhancement For 2020 Ram 2500 4WD With In-Bed Gooseneck Hitch
- Q&A: Installing A Trailer Wiring Harness On A 2027 Kia Sportage Hybrid
- Q&A: Where to Connect Curt Wiring 12V Hot Lead In 2026 Kia Sportage Hybrid
- Q&A: Recommended Brightest Interior 12v Lights for a RV
- Q&A: Recommended Brake Controller For An Itasca Ellipse Class A Motorhome
- Q&A: Roadmaster Parts For Flat Towing 2023 Ford Edge ST
- Q&A: Availability of Replacement Bullet Connectors for Trailer Lighting
- Article: Trailer Lighting Requirements
- Article: Trailer Tire Sizing
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: What Do I Need To Tow A Trailer?
- Article: How to Determine Tire/Wheel Diameter
- Article: How to Measure for Trailer Hitch Drop