What Tool Should Be Used To Knock Out An Inlet/Outlet Hole In A Valterra RV Water Tank
Updated 06/29/2023 | Published 06/28/2023
Question:
How do I punch out the holes?
asked by: Jordan
0
Expert Reply:
You can use a hole punch from your local hardware store to knock out the cap of any of the Valterra RV Water Tanks # R8048.
expert reply by:
Kevin C
0
Product Page this Question was Asked From
Valterra RV Water Tank - Non-Toxic - ABS Plastic - 48" x 8" x 16" - 24 Gallons
- RV Fresh Water Tank
- 21 - 30 Gallon Tanks
- 3/8 Inch Fittings
- 41 - 50 Inch Long
- 11 - 20 Inch Tall
- 0 - 10 Inch Wide
- Black
- Valterra
more information >
Continue Researching
- Q&A: What Is a Direct Replacement Water Heater for a 2020 Grand Design Transcend Xplor 243BH?
- Q&A: Trailer Coupler Solution for a 30 Degree Trailer Frame
- Q&A: Can I Use Both The RoadActive Suspension Enhancement With The Timbren Suspension Enhancement?
- Q&A: Location of Fill Ports on Valterra RV Water Tank
- Q&A: Replacing an Atwood GC6AA-10E gas/electric RV Water Heater
- Q&A: What Kind of Clearance do I Need from the Dometic RV Water Heater and Any Walls?
- Q&A: Replacement For Atwood GC6AA/10E 6-Gallon Water Heater
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Testing Brake Controls
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Ugly RV Makeover: How to Change Outdated RV Lighting
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices