No Power for Curt Echo Brake Controller on 2011 GMC Yukon
Updated 06/07/2023 | Published 06/05/2023
Question:
I have a curt 51180 that wont work with my 2011 gmc yukon, There is no power at the 7 pin connector. What do you suggest.
asked by: Bill B
Expert Reply:
I think I know what your issue is as it's rather common. The battery charge line wire under the hood is not attached to the power stud. I could explain this for you step by step here but it would be much easier for you to check out the attached help article below as it goes over all of this and more. This should then give you power so you can use the Curt Echo Wireless Brake Controller part # C51180.
Product Page this Question was Asked From
Curt Echo Wireless Brake Controller - 7-Way Plug-in w/ Bluetooth App - Up to 2 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Plug-In
- Smartphone App
- Under-Dash
- Up to 2 Axles
- Smartphone Display
- Multiple Trailers
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Will Weigh Safe True Tow Work With Jayco Jay Feather 19MRK
- Q&A: Do You Have a Gooseneck Hitch for a 2021 Chevy Silverado 5500?
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Which Wireless Trailer Brake Controller Is Best
- Article: Curt Echo Full Review
- Q&A: My Vehicle has a 4-Pin Trailer Plug, but Trailer has 7-Pin Trailer Plug
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: 7-Way Mounting Bracket for Use with ETBC7L and Curt Echo Mobile Brake Controller