Valve Body Thickness and Bolt Pattern of Bristol 1-1/2 inch Valve Body
Updated 05/16/2023 | Published 05/13/2023
Question:
On this Bristol 1 1/2” grey water waste valve. What is the diameter of the thickness of just a valve itself without the two end pieces that connect to the pipe, and what is the distance center to center between the bolts? Thank you,
asked by: Paul
1
Helpful Expert Reply:
Just the valve body thickness of the Bristol RV Waste Valve part # 34466N11AB that you referenced is 1/2 inch. This is a standard width for valve bodies just as the bolt pattern which is right at 2-1/2 inches square.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
LaSalle Bristol Waste Valve for RV Gray Water Tank - 1-1/2" Diameter - Hub to Spigot
- RV Waste Valves
- Straight Valve
- Single Waste Valve
- 1-1/2 Inch Valve Body
- Manual
- 1-1/2 Inch Hub
- 1-1/2 Inch Spigot
- Stationary Valve
- LaSalle Bristol
more information >
Continue Researching
- Q&A: Does SuperSprings Stabilizer Install on Top of Overload Spring of 2020 Ford F-350 Super Duty
- Q&A: Replacement Sewer Wye for Bristol V33B2R on Cobra Salem RV
- Q&A: Replacement LP Gas Detector Recommendation For Older Protechtor 2001 Series LP Gas Detector
- Q&A: Replacement For Atwood 36636 Carbon Monoxide & Propane Detector
- Q&A: Do Dexter Axles Rated For 3,500 Lbs Have 3" Diameter Tubes
- Q&A: Replacement Option For Atwood OD-5001 Water Heater
- Q&A: Is the Flair-It High Pressure Hose Able to be Used W/ a Pressure Washer
- Article: Trailer Wiring Diagrams
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Brake Controller Installation: Starting from Scratch