Momentary Test Switch Compatible With Ventline BM Series Vent Hood

Question

Question:

Looking for the momentary test switch to my ventline range hood monitor system. 8A 125vac 4A 250vac 16A 12vdc 6A 24vdc hood is model BM L9212 panel L5096-80 If unavailable would this switch work? I know I would have to turn it off after each use.

asked by: David

0

Expert Reply:

While I cannot verify the correct size switch which came with your Ventline range hood we do have a couple momentary switches that may work for you. You will need to measure your cutout to determine which momentary switch will fit.

1-1/8" tall x 9/16" wide # 37212705
3/4" tall x 1/2" wide # 37212815

The Fan Switch # BL1194-00 you found is the taller size of the two above.

expert reply by: Bud M

0

Answer 1

Hello James, thanks for reaching out. The Ventline L5113-03 comes back as an older circuit board that is unfortunately no longer available. If yours is in need of replacement, the only solution I can offer is to replace the vent entirely with a new…

view full answer...

Answer 2

The Momentary Switch #37212705 is not waterproof however the Single Momentary Reversing Switch #37213865 is going to be your best bet as it's water-resistant. This switch is similar to #37212705, is made in the USA, measures 1.12" tall x…

view full answer...

Answer 3

The install port for a brake controller in your 2019 Ford F-450 Cab and Cassis is behind the dash. You'll need to pull down on the dash panel and it will be behind the top section just to the right of the gear selector.

view full answer...

Answer 4

I do have an option for you, but the Mini-Momentary 12V Switch #37212815 is not water resistant or water proof. For a switch that is water resistant, you can use the Single Momentary Switch #37213845. The Single Momentary Switch #37213845 will have a…

view full answer...

Answer 5

Hello Todd. The Mini-Momentary 12V Switch #37212815 is made to fit a 3/4" x 1/2" cutout. It also has two connectors on the back so it sounds like this will meet all of your parameters.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 11

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 12

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Momentary Test Switch Compatible With Ventline BM Series Vent Hood

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching