Running Power Wire to 7-Way on Ford F-150
Updated 04/24/2023 | Published 04/21/2023
Products Featured in This Question
Question:
I have a 2013 f150 xlt 4x4 with an error message during towing “wiring fault on trailer” but I noticed after testing that do not have 12v on my 7 pin connector on the truck. Any idea what could be the problem for this error message
asked by: Buddy D
Expert Reply:
The error message is something you'll have to get looked at by Ford or a mechanic, but not having 12 volt power on the 7-way of your F-150 is something you can remedy. What you will do is activate it by purchasing the appropriate amount of 10 gauge wire # 10-1-1 (sold by the foot) as well as 40 amp In-Line Circuit Breaker # 9510 and run the wire from the positive battery terminal through the circuit breaker to the 1:00 pin on you F-150's 7-way, which is the 12 volt circuit.
Product Page this Question was Asked From
Continue Researching
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: What Gauge Wire Should be Used to Wire Trailer Brakes
- Article: Trailer Wiring Diagrams
- Q&A: What Size Wire And Circuit Breaker Should Be Used For The 12v Circuit On A 7-Way?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Parts Needed to Add Brakes to Ranger Boat Trailer
- Q&A: Recommended Front Hitch and TorkLift Tie Downs for a 2026 Ram 2500 Diesel w/a Factory Hitch
- Q&A: Recommended Built-In Convection Microwave to Replace a 0.9 Cu Ft Furrion Microwave Model FMSN09BL
- Q&A: Instructions to Wire a Trailer for Electric Brakes
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Parts Needed to Add Brakes to 3,500 lb Trailer Axle
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Measure Your Trailer Wheel Bolt Pattern