Can the Wiring Inside the Replacement Motor for Lippert PSX2 Stabilizer Be Replaced?
Question:
How do you replace wiring inside of motor?
asked by: Ricky O
0
Expert Reply:
The wiring inside the motor is not meant to be replaced. Instead, you'd just need to replace the entire motor with the Replacement Motor and Gear Box Assembly for Lippert Components PSX2 Electric RV Stabilizers # LC759091.
This is the correct replacement for the PSX2 stabilizers, so if you have a different one let me know and I'd be happy to help you find a replacement.
expert reply by:
Bryce D
0
Product Page this Question was Asked From
Replacement Motor and Gear Box Assembly for Lippert Components PSX2 Electric RV Stabilizers
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Gearbox
- Motor
- Lippert
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: What is Difference Between Lippert # PSX1 and PSX2 Stabilizer Jacks
- Q&A: Baggage Door Lock For 3-1/2" x 3-1/2" Hole Size
- Q&A: Will Global Link RV Baggage Door Slam Latch Fit a 1-1/4" Thick Door
- Q&A: Will Damage or Problems Happen if Lower RPM 18:1 Slide Out Motor is Used
- Q&A: What Width Vinyl Trim Fits into Tracks on Travel Trailer that are 1 inch Wide
- Q&A: Replacement Motor for Lippert Components PSX2 Electric RV Stabilizers
- Q&A: Installing the Wiring on Lippert Power Stabilizer Jack
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Performance Chips and Modules
- Article: How to Raise Your Travel Trailer Height
- Article: Top Weight Distribution Hitches for a Buttery Smooth Ride
- Article: Anti-Rattle Devices
- Article: Determining Trailer Tongue Weight