Dimensions of Bolt that Comes with Dutton Lainson Hand Winch Strap with Safety Hook DL24260

Question

Question:

What is the size of the mounting hardware for this strap?

asked by: Nathan

0

Expert Reply:

The bolt that comes with the Dutton Lainson Strap part # DL24260 that you referenced is 2-3/4 inches long and 1/4 inch in diameter.

expert reply by: Jameson C

0

Answer 1

Most trailer wiring problems are the result of a bad ground. What I would do is start with the connectors. Maker sure the connectors on both the trailer side and vehicle side are free of dirt and corrosion and that they are properly grounded. Next, I…

view full answer...

Answer 2

This sounds like a ground problem on the right side. The turn signal not working makes sense because with the brake lights, there is a constant signal coming through which is enough to make the lights illuminate on both sides like they should. But…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Dimensions of Bolt that Comes with Dutton Lainson Hand Winch Strap with Safety Hook DL24260

Product Page this Question was Asked From

Continue Researching