Does The 4" Wide Continuous Hinge Have A Rust Preventative Coating?  

The load capacity that you will want to take into consideration when choosing a strap is the safe working load limit of the strap. The Erickson Ratcheting Motorcycle Tie-Down Straps, #EM05710, has a working load limit of 400 lbs each. For your…

The difference between the Piano Hinge #SH300 and #H300 is the material the hinges are made of. The #SH300 is made of stainless steel which will provide excellent corrosion resistance whereas the #H300 is made from mild steel which won't resist…

The etrailer Enclosed Trailer Transition Plate #e32JR is 15" long and the width can be adjusted from 48" to 102" using the included hardware and mounting holes.

The main factor in choosing the correct replacement piano hinge is pin diameter which then in turn, denotes capacity. The hinge width and material are also all worthwhile contributing factors. The Continuous Piano Hinge part #MA85VR for example uses…

Yes, the 3" Wide Continuous Hinge - 6' Long - 1/4" Pin Diameter - Aluminum #MA74ZR can be cut down to fit your needs. I just recommend first removing the pin and separating each part before cutting them. You'll be better off cutting…

Installing the Hinges on your Side-Door Bar Lock Assembly, item #305736, is pretty much up to you and the construction of your trailer. You will need to purchase appropriate hardware to install the Side-Door Bar Lock that you purchased. It is best if…

We only have one piano hinge that is either 4" or 6" wide and constructed of either stainless steel or aluminum. That is the 4" Wide Continuous Hinge #MA38JR which is made of aluminum and 72" long with a 3/8" pin diameter. We…

The plunger for your TriMark 060-0460 is not offered as a replacement, however I do have another solution. Your best course of action is to install a complete replacement lock, like the Global Link RV Baggage Door Slam Latch #295-000078. This RV lock…

From a tire point of view the #AM32253DX matches perfectly as it comes with a ST205/75D15 just like what you have. The bolt pattern is a 5 on 5 inch which isn't the most popular bolt pattern but if that's what you have the wheel would bolt…

Here is a list of the tools needed to install the etrailer Enclosed Trailer Transition Plate #e32JR: - Tape Measure - Drill - Hex Drive Socket Adapter - 10mm Socket - 13mm Socket I have also added a link below to the instructions of the #e32JR for…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The side plates on the 3" Wide Continuous Hinge #MA65VR you found are 0.09" thick which is just under 3/32". We do have a 3" Wide #MA52VR which is 6' Long with a 1/2" pin that has 0.18" thick side plates which is…