Can Spindle Retainer Nut Be Used Instead of Tang Washer on Trailer Axle
Published 01/17/2023 >
Products Featured in This Question
Question:
My boat trailer Bear Trailer has an Axis? axle with E-Z Lube system. Can I change from using a spindle tang washer to a Nut Retainer Clip? If so, what other changes/parts would this require? Thanks,
asked by: Bill N
1
Helpful Expert Reply:
Yes, you can simply use the nut retainer part # 6-191 on your spindle nut instead of the tang washer setup and it would work just fine. The EZ lube fitting would not be an issue at all.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Replacement Nut Retainer for 6-191 Jam Nut
- Accessories and Parts
- Trailer Spindles
- Spindle Nut Retainer
- 1 Inch I.D.
- Dexter
more information >
Continue Researching
- Search Results: l44649
- Shop: Timken Bearing Kit for 3,500 lb Axles with #84 Spindle - Bearings L44649/L68149
- Search Results: l44649 kit
- Shop: Trailer Wheel Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Shop: Timken 473336 Grease and Oil Seal - Double Lip - I.D. 1.719" / O.D. 2.565" for 3.5K Axles
- Article: Trailer Wiring Diagrams
- Search Results: trailer bearings races seals caps
- Search Results: trailer dust caps
- Search Results: trailer wheels center caps
- Q&A: What is the Best Grease for Trailer Bearings
- Shop: Replacement Spindle Washer - Tang Type for E-Z Lube
- Shop: Replacement Trailer Spindle Jam Nut - 1" Diameter - Plain
- Shop: Cam-Action Lockable Door Latch w/ 36" Pipe for Enclosed Trailers - Zinc Plated Steel
- Shop: Replacement Trailer Wheel Bearing - L44649 - Qty 1
- Video: Tang Replacement Spindle Washer Feature Review
- Video: Spindle Nut Kit for EZ Lube Axles: The Breakdown
- Search Results: castle nuts
- Search Results: dexter ez lube grease caps
- Q&A: What Diameter Thread Are The DX82CR Spindle Retainer Nuts?
- Q&A: Is There a Dexter Park K71-622-00 Available
- Q&A: Trailer Wheel Bearings Burning Out Repeatedly After Little Mileage
- Q&A: Washers Compatible With 7/8 Inch Castle Nut
- Video: Standard Axle Brake Assembly Hub and Drum Installation FAQ
- Video: Bearing Kit for Trailer Brakes w/ 8" or 10" Hub/Rotor Review
- Video: Detailed Breakdown of the Bearing Kit for Trailer Brakes w/ 8" or 10" Hub/Rotor
- Q&A: Bearing Buddy and Bearing Kit Recommendation for 3,500 lb Axles
- Q&A: Which Bearing Buddy Fits Lippert 3,500 lb Trailer Axle
- Video: Timken Bearing Kit Installation - Enclosed Trailer
- Video: Detailed Breakdown of the Replacement Spindle Washer

