Can Brake Controller Output be Checked with Override Lever
Updated 01/16/2023 | Published 01/14/2023
Products Featured in This Question
Question:
can you check 7 pin for voltage at pin for trailer brake using the manual activation button while trailer is not hooked up
asked by: VICTOR M
0
Expert Reply:
Yes, if you slide the manual override lever of a brake controller you can then use a circuit tester like part # PTW2992 to test for voltage on the output pin which would be in the 5:00 position.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Spectrum Trailer Brake Controller - Dash Mounted Knob - Up to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Plug-In
- Dash-Mounted Knob
- Behind-Dash
- Up to 4 Axles
- Indicator Lights
- Multiple Trailers
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Comparing Redarc Liberty and Curt Spectrum Brake Controllers For a 2023 GMC Sierra 1500
- Q&A: Which Wireless Trailer Brake Controller Is Best
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: How Do I Know How Much of a Drop I Need on an Adjustable Hitch for Travel Trailer?
- Q&A: Comparing the Curt Spectrum Brake Controller to Redarc Tow-Pro Elite
- Q&A: Troubleshooting Curt Spectrum Brake Controller - No Lights On Control Knob
- Q&A: What Lights On Curt Spectrum Are Supposed to Activate When Pressing Brake Pedal and No Trailer?
- Q&A: Differences Between the Redarc Tow Pro Trail and Elite
- Article: Trailer Wiring Diagrams
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Best Bike Racks for Electric Bikes