Will Existing Cord Fit Snugly In Mighty Cord Replacement RV Plug

Question

Question:

Will other black cords fit snug when placed through the end of plug? No slop? Are these your best replacement ends? Thanks

asked by: Tom

0

Expert Reply:

Yes, your cord will be snug following the installation of the female # A10-R30VP and male # A10-P30VP plugs. The internal clamp will hold the cord securely in place so there is no slop. These have a polyester construction, are weather resistant, and the best replacement option.

expert reply by: Robin H

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Hi Monty, The mounting holes for the round cable hatch #A10-2130VP will not be covered by the SmartPlug RV Power Inlet and Connector - 30 Amp #SM27FR. I've added a photo below of the mounting dimensions of the #SM27FR and as you can see they are…

view full answer...

Answer 4

Hey Victor, thanks for reaching out! Your Thetford 31684 has a rough-in measurement of 7-5/8" so the Thetford Aqua-Magic VI RV Toilet #TH37SE is the best replacement for you because it has the same profile so no modifications are needed to get…

view full answer...

Answer 5

Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…

view full answer...

Answer 6

A great connector that is compatible with the #A10-50FDT you were looking at is the Epicord 50 Amp Twist Lock Power Inlet part #277-000140. The one mentioned in the video just changed part numbers because it is now available in black #A10-50INBKVP…

view full answer...

Answer 7

Here is a list of the female 30amp pigtails and connectors we have. Mighty Cord Replacement Pigtail #A10-30PFVP Mighty Cord Replacement Hardwire RV Plug #A10-R30VP Mighty Cord Replacement Twist Lock Connector #A10-30FDT and Cover #A10-30CV

view full answer...

Answer 8

Sounds like you have the trailer hub part #8-247-50UC3-EZ installed on your trailer. That means for a grease seal you would need the part #RG06-050.

view full answer...

Answer 9

This is an interesting (extremely frustrating) issue we've recently discovered with a lot of the new GM trucks, specific to the Bargman 7-Ways like the part #54006-057 you mentioned having. I can at least assure you that you're not doing…

view full answer...

Answer 10

I have found the Mighty Cord Replacement Pigtail #A10-30PMVP to be the best option when replacing a power cable end on a camper using a Hatch #A10-2140VP to store the cable. The replacement ends like the Hughes #HU93FR you found are too large to fit…

view full answer...

Will Existing Cord Fit Snugly In Mighty Cord Replacement RV Plug

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching